Chlorine dioxide generator automatic precautions

1. Before the first operation, sufficient fresh water must be added to the equipment and no empty machine is allowed to operate;

2. When the metering pump stops feeding, the ejector should continue to operate for more than one hour, so that the chlorine dioxide gas in the reactor can be fully evacuated to avoid gas overflow from the inlet pipe.

3. If the power source suddenly stops water, the metering valve should be closed immediately.

4. Hydrochloric acid is a strong acid. Operators should wear protective gloves. The raw material NaCLO2 is prohibited from being stored together with various kinds of acids and away from fire sources.

5, equipment temperature control tank should be frequently replenishment, to prevent damage to the heater, the controller has a protective device, when the tank water level is lower than the set value, the control cabinet on the fault light, immediately replenishment.

6, chlorine dioxide has a strong oxidizing, soft plastic pipe equipment, easy aging and sealing is not strict, should be regularly checked and replaced.

7. Periodically clean the sediment in the reactor. If it is found that the liquid level of the reaction level tube exceeds the normal limit, it means that the sediment is too much and should be flushed immediately. And check the quality of raw materials.

8, in the case of raw materials containing impurities are easy to plug should pay attention to clean up.

9. The equipment is heated by a water bath. When the equipment is not in use, the water is heated and the reaction liquid is let off to prevent freezing at temperatures below 0 degrees and damage the equipment. If the equipment is used intermittently, to keep the heated water and the reaction liquid from freezing, keep the temperature control box working continuously.

Anticorrosion Pigments, Inkjet Receptive Coating, Matting Agent